OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P235F

Cylinder 11 Pressure Sensor Circuit High

P235F is logged when the cylinder 11 pressure sensor signal remains above its plausible maximum. Only twelve-cylinder engines have this cylinder, and no maker documents the code; the Saab 9-5 diesel serves as the model with P0398 for cylinder 1, a Type B code that needs more than 2 s over the threshold. In that wiring layout three faults produce a high reading: an open low reference, an open signal wire and a reference or signal shorted to battery voltage. Saab's test plan therefore measures less than 5 Ohm between the low reference and ground, and it requires infinite resistance between every sensor terminal and the plug body – broken insulation inside the glow plug would also distort the signal. The cylinder runs on without pressure feedback; P235E is the opposite case.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 5F

Possible causes

  • Low reference (ground) wire of the sensor open high
  • Signal wire interrupted or connector off medium
  • Reference or signal shorted to battery voltage low
  • Insulation failure between sensor terminals and plug body low

Symptoms

  • Check engine light after two trips
  • Implausibly high fixed pressure value for cylinder 11

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P235F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication