OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P235E

Cylinder 11 Pressure Sensor Circuit Low

With P235E the signal of the cylinder 11 combustion pressure sensor is too low, typically close to zero. No manufacturer documents this code, as twelve-cylinder engines with pressure sensors are not described publicly; the analogue is P0397 for cylinder 1 in Saab's 9-5 diesel, where a low signal must persist beyond 2 s with the engine running before the Type B code is logged. The first check there concerns the supply: 4.8 to 5.2 V on the reference terminal with ignition on; less voltage means the reference is interrupted or shorted to ground. Across reference and low reference of the plug itself, 3 to 12 Ohm are expected. A signal wire chafed through to the cylinder head also drags the input down. With bank-wise numbering the plug sits between cylinders 10 and 12, so their harness branches deserve a look too.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 5E

Possible causes

  • 5 V reference interrupted or shorted to ground high
  • Signal wire chafed through to ground medium
  • Sensor glow plug outside its 3–12 Ohm specification medium

Symptoms

  • Warning lamp after the second faulty trip
  • Peak pressure of cylinder 11 shown as zero

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P235E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication