OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P235D

Cylinder 11 Pressure Sensor Circuit Range/Performance

P235D is set when the combustion pressure reported for cylinder 11 is electrically valid yet does not fit the engine's state – for example a compression peak that is clearly off while no fuel is being injected. Only engines with twelve cylinders have a cylinder 11, and none of them is publicly documented with pressure sensors, so no manufacturer describes this code. CARB demands rationality checks of input components in both directions, reading too high and too low. BorgWarner's piezo-resistive pressure glow plug is calibrated and programmed specifically for each customer: a plug taken from another engine application can therefore read wrong while being electrically sound. Carbon on the heater rod or a leaking seal at the plug seat are other likely causes. The cylinder-1 counterpart is P0396; drivers seldom notice more than the lamp.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 5D

Possible causes

  • Glow plug with calibration for another engine application fitted medium
  • Deposits on the heater rod distort the reading high
  • Seal at the glow plug seat leaking medium

Symptoms

  • Check engine light on
  • Driving behaviour practically unchanged

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P235D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication