P235A
Cylinder 10 Pressure Variation High
P235A is the counterpart to P2359: the cylinder 10 pressure signal swings more than the combustion can explain, with spikes or steps from one cycle to the next. A public manufacturer description of this tenth-cylinder code does not exist. In the Saab 9-5 diesel the cylinder-1 version P039D belongs to the signal performance group; it is Type B and responds within 0.2 s of leaving its window. Electrical noise is the usual reason: a signal wire with damaged shielding or chafed insulation, a poor engine ground, or unstable sensor electronics. Genuinely irregular combustion is rarer, for instance when an injector dribbles after closing. VW's TDI bulletin recommends watching the maximum pressure reading while flexing the harness – jumps then betray the wiring. The warning lamp is mostly the only sign.
Possible causes
- Interference on a damaged or poorly shielded signal wire medium
- Poor engine ground or corroded ground point medium
- Sensor electronics delivering an unstable signal medium
- Injector dribbling after closing, combustion varies low
Symptoms
- Check engine light on
- Usually no noticeable symptoms
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P235A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-diesel/fault-diagnosis-diagnostic-trouble-codes/dtc-p0399-p039c-p039d-p03a3-p03a6-p03a7-p03ad-p03b0-p03b1-p03b7-p03ba-or-p03bb
- static.nhtsa.gov/odi/tsbs/2014/MC-10120324-9999.pdf
- law.cornell.edu/regulations/california/13-CCR-1968.2