P2358
Cylinder 10 Pressure Too High
P2358 indicates that the pressure determined for cylinder 10 exceeds its upper expectation. No manufacturer documents this cylinder-10 code. The closest published cases are Audi bulletins for the 2015 S3 with the 2.0 TFSI engine code CYFB: there the pressure-too-high codes of cylinders 1 to 4 (P039B00 to P03B900) showed up with misfire codes and P130A00, the entry for a cylinder the ECM has hidden, that is, switched off. The EPC lamp lit. Faulty software was to blame; an update to part number 8V0 906 259H, version 0002, cured it. So a petrol engine without glow plugs uses this family too. On a diesel with pressure sensors, a true excess points to surplus or early fuel, such as a leaking injector, or to a sensor whose output has crept upward. With the cylinder shut off, power drops noticeably.
Possible causes
- Engine control software misjudging combustion (update available) medium
- Injector of cylinder 10 leaking or over-delivering medium
- Pressure sensor reading too high low
Symptoms
- Warning lamp on, sometimes together with misfire codes
- Hard, knocking combustion noise
- Reduced power if the cylinder is switched off
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2358
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.