P2356
Cylinder 10 Pressure Sensor Circuit Intermittent/Erratic
P2356 points to a cylinder 10 pressure signal that drops out or jumps for moments instead of failing permanently. No manufacturer covers cylinder 10 publicly. For four-cylinder TDI engines, a 2014 Volkswagen bulletin lays out a sensible order: first push and pull the glow plug connector – a felt click or a plug that comes off easily is already the fault – then swap the plug with a neighbouring cylinder to see whether the code moves with it, and finally move the harness while watching the maximum cylinder pressure value. On a V10 with bank-wise numbering the obvious swap partner is cylinder 9 in the same bank. According to VW, the MIL can need a second drive cycle. In Saab's GM-built diesel, the erratic codes react after only 0.2 s out of range.
Possible causes
- Connector not fully seated, contact lost under vibration high
- Wire break inside the insulation or chafe point that opens intermittently medium
- Glow plug sensor electronics failing intermittently medium
Symptoms
- Warning lamp that comes and goes
- Fault hard to reproduce in the workshop
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2356
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.