OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2355

Cylinder 10 Pressure Sensor Circuit High

P2355 means the cylinder 10 pressure signal is stuck above its upper limit. Taking the Saab 9-5 diesel with GM's 2.0 engine as the model, the Type B high codes for its four cylinders (P0398 on cylinder 1) wait until the signal has stayed above the threshold for over 2 s with the engine running. An interrupted signal or low reference circuit lets the input float upward, and the scan tool then displays a fixed 10,000 kPa instead of a value inside the normal 0 to 9,000 kPa. Saab's way to tell wiring from sensor: bridge signal and low reference at the harness plug with a fused jumper; the reading must then fall below 50 kPa, otherwise the fault lies in the harness or the ECM. No manufacturer documents P2355 for cylinder 10 itself; P2354 is the low counterpart.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 55

Possible causes

  • Signal or low reference wire open, connector pulled off high
  • Signal or reference shorted to a voltage source medium
  • Sensor electronics driving the output high low

Symptoms

  • Check engine light after two trips
  • Peak pressure for cylinder 10 frozen at a very high value
  • No obvious driveability complaint

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2355

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication