OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2354

Cylinder 10 Pressure Sensor Circuit Low

P2354 reports that the signal of the cylinder 10 pressure sensor stays below its lower limit. The pattern known for this fault type comes from Saab's 9-5 diesel with its GM 2.0 engine: its low codes for the four cylinders (P0397 on cylinder 1) demand that a running engine sees the signal under the threshold for longer than 2 s, run once per trip and are Type B, so the MIL waits for a second failed trip. For cylinder 10 no manufacturer publishes the code. A quick check from that procedure: with the sensor connector unplugged, the scan tool should show more than 10,000 kPa; a lower reading points to a signal wire shorted to ground. A missing 5 V reference pulls the value down as well. On V10 engines cylinder 10 is the last one of its bank, so the plug is often awkward to reach.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 54

Possible causes

  • Signal wire shorted to ground, e.g. chafed on the cylinder head high
  • 5 V reference interrupted or shorted to ground medium
  • Internal fault of the pressure-sensing glow plug medium

Symptoms

  • Check engine light after the second faulty trip
  • Scan tool shows peak pressure near zero for cylinder 10
  • Driving behaviour normally unchanged

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2354

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication