P2353
Cylinder 10 Pressure Sensor Circuit Range/Performance
P2353 means the cylinder 10 pressure sensor delivers a signal that is electrically within limits but not believable for the current operating point – the reading is skewed, not cut off. CARB expects input sensors to be checked for such rationality faults, not just for open or shorted circuits. How an ECM can do this is visible in Saab's 9-5 diesel: it locates top dead centre from the pressure peak on overrun, corrects the offset of the crank trigger wheel and keeps the result in EEPROM. A drifted sensor, a heater rod that no longer passes pressure on to the measuring diaphragm, or a replacement plug whose calibration does not suit the engine would all fail such a test. No manufacturer documents P2353 for cylinder 10. The engine runs normally; only pressure-based control of this cylinder is lost.
Possible causes
- Sensor offset drifted with age and heat high
- Carbon on the heater rod hampers pressure transfer to the diaphragm medium
- Replacement glow plug with calibration for another engine low
Symptoms
- Check engine light on
- No noticeable change in engine behaviour
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2353
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-diesel/fault-diagnosis-diagnostic-trouble-codes/dtc-p0399-p039c-p039d-p03a3-p03a6-p03a7-p03ad-p03b0-p03b1-p03b7-p03ba-or-p03bb
- borgwarner.com/aftermarket/diesel-cold-start-ignition/pressure-sensor-glow-plugs