OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2352

Cylinder 10 Pressure Sensor Circuit

P2352 is the catch-all code for the electrical circuit of the cylinder 10 combustion pressure sensor, meant for engine computers that make no distinction between low and high. A tenth cylinder exists only on V10 and V12 engines. Under the bank-by-bank numbering of Ford and Audi it is the rearmost cylinder of the second bank; Chrysler counts along the crankshaft, which makes it the last one, at the back, on the even-numbered bank. Publicly, no maker lists this code: the known pressure-sensing glow plug systems sit on four-cylinder diesels, such as VW's US 2.0 TDI with its own codes P13CE to P13E3. CARB wants circuit faults of input sensors watched continuously, sampled at least twice per second. Suspects are the connector, the harness and the sensor itself; meanwhile the ECM lacks combustion feedback for this cylinder.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 52

Possible causes

  • Glow plug/sensor connector of cylinder 10 not fully latched or corroded high
  • Harness branch to the rear cylinder of the bank chafed or heat-damaged medium
  • Electronics in the pressure-sensing glow plug failed medium

Symptoms

  • Check engine light on
  • Engine usually runs as before
  • Combustion noise may become slightly harder

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2352

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication