P234F
Cylinder 9 Pressure Variation Low
P234F flags that the pressure signal of cylinder 9 changes too little: the rise and fall the ECM expects across each combustion cycle is missing or very small. For cylinder 9 there is no manufacturer documentation. In the Saab 9-5 with GM's 2.0 CDTI, the cylinder-1 analogue is P039C, labelled pressure variation too low, with three sub-faults; it reacts after more than 0.2 s out of range with the engine running and is grouped with the erratic code as a signal performance fault. Saab does not explain the exact measurement. A flat signal fits a sensing pin stuck in carbon that no longer passes on the pressure, a sensor that has lost sensitivity, or a cylinder that hardly builds up pressure. Usually only the warning lamp shows; the high counterpart is P2350.
Possible causes
- Sensing element of the glow plug stuck by carbon high
- Sensor lost sensitivity through ageing medium
- Cylinder 9 builds up little pressure (compression or injection fault) low
Symptoms
- Check engine light on
- Usually no change in engine behaviour
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P234F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-diesel/fault-diagnosis-diagnostic-trouble-codes/dtc-p0399-p039c-p039d-p03a3-p03a6-p03a7-p03ad-p03b0-p03b1-p03b7-p03ba-or-p03bb
- law.cornell.edu/regulations/california/13-CCR-1968.2
- borgwarner.com/aftermarket/diesel-cold-start-ignition/pressure-sensor-glow-plugs