OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P234A

Cylinder 9 Pressure Sensor Circuit Low

P234A means the signal of the cylinder 9 combustion pressure sensor stays below its permitted minimum. No published manufacturer document covers cylinder 9; the closest pattern is the GM-built 2.0 CDTI diesel of the Saab 9-5, whose cylinder 1–4 low codes (P0397 for cylinder 1) set after more than 2 s below threshold with the engine running, checked once per operating cycle, as Type B – the MIL comes on after the second failing trip. A scan tool then shows a peak pressure of 0 kPa. Electrically this points to a lost 5 V reference, a reference shorted to ground or a signal wire touching ground. Saab expects 3 to 12 Ohm between reference and ground at the plug. Combustion control for the cylinder is suspended, which usually goes unnoticed. The high counterpart is P234B.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 4A

Possible causes

  • 5 V reference interrupted or shorted to ground high
  • Signal wire shorted to ground medium
  • Sensor in the glow plug defective medium

Symptoms

  • Check engine light after two trips
  • Peak pressure reads 0 kPa on the scan tool
  • Driving behaviour mostly unchanged

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P234A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication