P2348
Cylinder 9 Pressure Sensor Circuit
A cylinder pressure sensor, usually built into the glow plug of a diesel, reports the combustion pressure of one cylinder so the ECM can trim injection for it. P2348 is the general circuit code for the sensor of cylinder 9, meant for modules that do not split faults into low and high. No manufacturer documents this code publicly: the systems found so far sit on four-cylinder diesels – the GM-built 2.0 CDTI of the Saab 9-5 relies on the split low/high codes, VW's US 2.0 TDI its own P13CE series – and an engine with a ninth cylinder and such sensors is not documented. The text therefore relies on CARB's circuit-monitoring duty for input sensors and on the cylinder-1 analogue P0395. Wiring, connector and sensor are the suspects; the ECM simply stops combustion control for that cylinder.
Possible causes
- Sensor or glow plug connector of cylinder 9 loose or corroded high
- Reference, signal or ground wire damaged medium
- Pressure sensor electronics faulty medium
Symptoms
- Check engine light on
- Often no noticeable change in driving
- Possibly slightly harsher combustion noise
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2348
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.