OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2330

Ignition Coil K Primary Control Circuit Low

P2330 belongs to coil K, the eleventh coil, which only twelve-cylinder petrol engines have – V12 units such as those built by BMW, Mercedes-Benz, Lamborghini or Ferrari, or the VW group's W12. No manufacturer documents this code publicly; the published coil lists stop earlier (Ford at J, GM at H). The meaning follows from the analogous lower codes: the module sees the coil K driver line held at ground potential, as GM describes for its cylinder 8 code P2321 (short to ground judged against controller voltage limits, 50 of 63 samples). Under CARB's comprehensive component rules such a circuit fault on an output must be detected. Wiring and connector of that one coil should be checked before the module is suspected; an open circuit would be P0361.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 30

Possible causes

  • Coil K shorted internally high
  • Coil K control wire damaged and grounded in the bank harness medium
  • Coil K driver in the engine module faulty low

Symptoms

  • Check engine light on
  • Cylinder 11 not firing
  • Slight roughness, often hard to feel on a V12

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2330

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication