OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P232C

Cylinder 11 Fuel Injector A Offset Learning At Max Limit

P232C is the upper-limit partner of P232B for injector A in cylinder 11. The small-quantity learning has found that this injector needs far more energizing time than the nominal map to produce the expected torque pulse, and the stored correction has hit its maximum at one or more rail pressure levels. Typical reasons are coking, wear or a sticking needle, so the injector delivers too little or opens late. GM's 2018 diesel tables describe the logic for cylinders 1 to 8: every new learned value is checked, the saturation status is kept per pressure level in non-volatile memory, the code sets if any level is saturated, and it is Type B (MIL after two trips). CARB requires such a fault when a fuel feedback has run out of authority. Only twelve-cylinder diesels have a cylinder 11; no maker publishes P232C.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 2C

Possible causes

  • Injector of cylinder 11 coked, worn or sticking (delivers too little) high
  • Injector correction code missing or wrong after replacement medium
  • Poor fuel quality or contamination promoting deposits low
  • Disturbed crankshaft speed signal low

Symptoms

  • MIL on after two trips
  • Rough idle or uneven running at low load
  • Possibly harder starting or more smoke

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P232C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication