OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P232B

Cylinder 11 Fuel Injector A Offset Learning At Min Limit

Common-rail diesels keep a small-quantity correction for every injector. During overrun fuel cut the module fires one injector alone with a tiny known amount (GM: about 1.5 mm³), judges the torque from crankshaft acceleration and records how much the energizing time has to change at each rail pressure level. P232B says this learned value for injector A of cylinder 11 has reached its lower bound at one or more pressure levels: the injector needs much less time than nominal, so it delivers too much or opens early. CARB demands a fault once such a feedback correction has used up its range. An eleventh cylinder means a V12 diesel; among passenger cars only Audi's Q7 V12 TDI, sold from 2008 to 2012, had one. No manufacturer documents P232B publicly; P232C is the upper limit.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 2B

Possible causes

  • Injector of cylinder 11 leaking or delivering too much at small quantities high
  • Injector correction code not or wrongly entered after replacement medium
  • Disturbed crankshaft speed signal falsifying the torque evaluation low
  • Engine software calibration issue low

Symptoms

  • Check engine light on
  • Often no noticeable change; possibly louder combustion noise or rough idle
  • Possibly smoke or higher fuel consumption

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P232B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication