OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2327

Ignition Coil J Primary Control Circuit Low

P2327 is the highest ground-side coil code Ford publishes: its driver short-circuit-low list in the 2012 and 2020–2023 OBD summaries runs from P2300 up to P2327 and stops there, matching a ten-coil engine such as the 6.8-litre Modular V10. Coil J serves the tenth cylinder in Ford's count. The check runs continuously between 200 rpm and about 3,200 rpm under positive torque and finishes in under a second; Ford's 2014 code list ranks it as a MIL code. Because Ford also cuts the injector of a faulty-coil cylinder, a grounded coil J line feels like a dead cylinder that keeps coming back. Engines with twelve cylinders could log it too, but no such maker documents it. Related: P0360 for an open circuit, P0310 for misfire on cylinder 10.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 27

Possible causes

  • Coil J (cylinder 10) failed with internal short high
  • Coil J signal wire shorted to ground near the rear of the engine medium
  • Corroded or water-filled coil J connector medium
  • PCM driver for coil J defective low

Symptoms

  • Check engine light on
  • Cylinder 10 missing, engine shakes
  • Higher fuel consumption from cylinder shut-off cycles

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2327

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication