OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2325

Ignition Coil I Primary Control Circuit High

P2325 flags a short to voltage on the trigger line of coil I, the ninth ignition output. Ford is again the only maker that lists it publicly: in its OBD summaries P2325 sits among the codes for a coil driver shorted high, and the 2014 Ford code list shows it as a MIL-lighting code checked with the engine running. The PCM judges current and voltage on the driver against open and short limits; when it trips, it stops fuel to that cylinder to protect the catalyst, waits 30 s and turns the injector back on, repeating the cut within about 0.1 s if the fault is still there. That makes the symptom a pulsing loss of one cylinder rather than a steady miss. On a Ford V10 the cause is mostly the coil or a chafed wire; P2324 is the ground-side fault on the same coil.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 25

Possible causes

  • Coil I control wire touching a 12 V feed high
  • Coil I primary winding damaged medium
  • PCM driver stage for coil I faulty low

Symptoms

  • Check engine light on
  • Cylinder 9 drops out in roughly 30 s cycles
  • Uneven idle and vibration

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2325

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication