OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P231F

Cylinder 12 Air-Fuel Ratio Imbalance - Adjustment At Limit During Balance

P231F closes the balance-limit series at cylinder 12, the last cylinder of a twelve-cylinder engine. It says the balancing routine has used up the fuel trim for that cylinder without matching it to the rest. Public manufacturer documentation is missing, and the NHTSA index contains no bulletin naming it. CARB's monitor requirement, and its demand that the stored code identify the cylinder wherever the method allows, apply to these rare engines as well. A V12 has two independent banks, so compare the matching bank code (P219A or P219B) with the misfire counter P0312 and with P21A7 before fitting parts. Mercedes' bulletins for its four-cylinders, where worn valve seats caused balancing faults, are a reminder that the injector is not always the culprit.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 1F

Possible causes

  • Injector of cylinder 12 delivering too much or too little (deposits, wear) high
  • Air leak at the intake port or injector seal of cylinder 12 medium
  • Valve of cylinder 12 not sealing (worn seat or guide), low compression medium
  • Poor contact at the connector of injector 12 low

Symptoms

  • Check engine light on
  • Rough idle, possibly misfire on cylinder 12
  • Higher fuel consumption or exhaust smell

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P231F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication