OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P231D

Cylinder 10 Air-Fuel Ratio Imbalance - Adjustment At Limit During Balance

P231D is the cylinder 10 code of the balance-limit series. On a V10 it marks the last cylinder, on a V12 one of the inner ones; smaller engines cannot set it. The individual fuel correction for cylinder 10 has reached its end stop while the controller tried to equalise the mixture. No maker publishes a description, and no NHTSA bulletin lists it. The principle is the one Mercedes describes on its M260/M264 four-cylinders as injector quantity adjustment for cylinder balancing, with P1CEF85 when it nears the upper limit, there often caused by worn valve seats. CARB's imbalance monitor (13 CCR 1968.2 (e)(6.2.1)(C)) applies to these engines too. Look at injector 10, the intake runner seal and valve tightness, and check whether P0310 or P21A5 are stored as well.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 1D

Possible causes

  • Injector of cylinder 10 delivering too much or too little (deposits, wear) high
  • Air leak at the intake port or injector seal of cylinder 10 medium
  • Valve of cylinder 10 not sealing (worn seat or guide), low compression medium
  • Poor contact at the connector of injector 10 low

Symptoms

  • Check engine light on
  • Rough idle, possibly misfire on cylinder 10
  • Higher fuel consumption or exhaust smell

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P231D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication