OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P230F

Cylinder 6 Air-Fuel Ratio Imbalance - Adjustment At Limit During Balance

P230F is the balance-limit code for cylinder 6 and can only appear on engines with six or more cylinders, inline sixes, V6 units and larger. On a V6, cylinder 6 shares its bank and front oxygen sensor with two others, so its individual trim has to be estimated from that bank signal or from crankshaft speed. No maker documents P230F publicly, and no NHTSA bulletin mentions it. The series jumps from here to P231A for cylinder 7, because P2310 to P2319 are taken by ignition coil codes. Mercedes, which uses the series on its AMG M177 V8, shows that such a code can also be a software matter. Checks for cylinder 6 follow the usual order: injector delivery, intake sealing at that port, compression and valve tightness. P21A1 and P0306 belong to the same cylinder.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 0F

Possible causes

  • Injector of cylinder 6 delivering too much or too little (deposits, wear) high
  • Air leak at the intake port or injector seal of cylinder 6 medium
  • Valve of cylinder 6 not sealing (worn seat or guide), low compression medium
  • Poor contact at the connector of injector 6 low

Symptoms

  • Check engine light on
  • Rough idle, possibly misfire on cylinder 6
  • Higher fuel consumption or exhaust smell

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P230F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication