OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P230D

Cylinder 4 Air-Fuel Ratio Imbalance - Adjustment At Limit During Balance

P230D flags cylinder 4, so the engine needs at least four cylinders. The balancing function has run the individual fuel trim for that cylinder to its limit and the mixture still deviates. Audi's 2020 bulletin for the 2.0 TFSI (third-generation EA888) shows that this four-cylinder reports imbalance through the P230 series, which gives the code a real home, although the bulletin itself only names P230B and P230E. Mercedes lists irregular mixture formation at cylinder 4 among the faults caused by leaking valve seats on its M260/M264 four-cylinders. Swapping injector 4 with a neighbour shows whether the fault follows the injector; if it stays, look at intake sealing and compression. P219F and P0304 are the matching imbalance and misfire codes. The MIL comes on.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 0D

Possible causes

  • Injector of cylinder 4 delivering too much or too little (deposits, wear) high
  • Air leak at the intake port or injector seal of cylinder 4 medium
  • Valve of cylinder 4 not sealing (worn seat or guide), low compression medium
  • Poor contact at the connector of injector 4 low

Symptoms

  • Check engine light on
  • Rough idle, possibly misfire on cylinder 4
  • Higher fuel consumption or exhaust smell

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P230D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication