OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P230C

Cylinder 3 Air-Fuel Ratio Imbalance - Adjustment At Limit During Balance

P230C is the balance-limit code for cylinder 3. On three-cylinder engines this is the last cylinder of the row; on fours and larger engines it sits further inside. The engine control trims the fuel of each cylinder separately to even out mixture differences, and P230C means the trim for cylinder 3 is used up. No manufacturer documents this exact code publicly and the NHTSA index lists no bulletin for it. Comparable data come from VW, whose 2014 Beetle table derives the plain imbalance codes from a per-cylinder fuel correction found by deliberate leaning, and from Mercedes, whose M260/M264 bulletins blame a leaking valve seat when cylinder 3 shows irregular mixture formation. A compression and leak-down test on cylinder 3 is worth doing before injectors are swapped.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 0C

Possible causes

  • Injector of cylinder 3 delivering too much or too little (deposits, wear) high
  • Air leak at the intake port or injector seal of cylinder 3 medium
  • Valve of cylinder 3 not sealing (worn seat or guide), low compression medium
  • Poor contact at the connector of injector 3 low

Symptoms

  • Check engine light on
  • Rough idle, possibly misfire on cylinder 3
  • Higher fuel consumption or exhaust smell

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P230C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication