OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2307

Ignition Coil C Primary Control Circuit High

P2307 sets when the coil C control line, cylinder 3 in most layouts, is shorted to a voltage source. On GM's 3.6-litre LLT V6 (2008) the check is a continuity test against voltage that runs below 6,000 rpm with the battery between 9.99 and 18.1 V and needs 4 s at a stretch or 50 s in total. Do not trust the letter blindly on Ford: special service message 52342 for the 2021–2024 Bronco 2.3 and 3.0 EcoBoost explains that the PCM may file P2307 and its neighbours under the wrong cylinder, while still cutting fuel to the cylinder it has blamed. Ford's advice is a power balance test with its scan tool; the cylinder that drops out without a code of its own is the one to repair. Saab's Trionic 8 treats an open line on cylinder 3 as P2307 as well.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 07

Possible causes

  • Coil C control wire touching a battery-voltage line high
  • Coil C with an internal short to its supply medium
  • Code filed against the wrong cylinder by PCM software (Ford Bronco SSM 52342) medium
  • Broken control wire on systems reporting opens here (Saab Trionic 8) low

Symptoms

  • Check engine light on
  • Cylinder 3 misfires
  • Power loss, engine runs rough

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2307

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication