P2306
Ignition Coil C Primary Control Circuit Low
With P2306 the engine module has seen the output for coil C, cylinder 3 at GM, Saab and VW, dragged down to ground. Ford explains where such a fault can sit on engines whose coils carry their own driver: the coil-driver chip in the PCM watches current and voltage at its output, so the culprit may be the PCM, the harness, the plug-in connection at the coil or the driver electronics inside the coil – but not the windings, which only the misfire monitor sees. The check is continuous, needs 200 rpm, positive torque and 11–16 V and decides within 1 s. VW's 2014 tables set the low code when the line draws more than 24 mA. Saab's Trionic 8 pairs cylinder 3 with cylinder 1 for its combustion signal. FCA lists P2306-00 for 2023 Alfa Romeo Stelvio 2.0 turbo engines fixed by PCM software.
Possible causes
- Driver electronics inside coil C defective high
- Coil C control wire grounded through chafing or a pinched harness medium
- Corroded or bent pins at the coil C connector medium
- PCM output or software (FCA 2023 reflash) low
Symptoms
- Check engine light on
- Misfire on cylinder 3
- Uneven idle, possibly cylinder shut-off
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2306
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.