OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2304

Ignition Coil B Primary Control Circuit High

P2304 means the control line of coil B (cylinder 2) is held at too high a voltage – usually a short to a supply line, sometimes an internal coil fault. In VW's 2014 tables a primary control circuit counts as high once its signal voltage exceeds about 5.1–7.0 V, while the low code reacts to a current above 24 mA; the Touareg six-cylinder petrol table (engine code CGRA) names the coils directly by cylinder number. Saab's Trionic 8 (9-3, 2003) sets P2304 when more than 2 V remain on the line while the module grounds it, an open line included. A rarer cause is the module itself: Polaris put six 2026 Slingshots on dealer hold because their ECM triggered P2304, and shipped replacement ECMs. Ford's Bronco bulletin 24-2406 lists P2304 among the codes that a PCM reflash may need to remap to the right cylinder.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 04

Possible causes

  • Coil B control wire shorted to a voltage-carrying line high
  • Internal fault in coil B or its built-in driver medium
  • Engine module fault (Polaris Slingshot 2026: ECM replaced) medium
  • Interrupted control line on systems that report it here (Saab Trionic 8) low

Symptoms

  • Check engine light on
  • Cylinder 2 misfiring
  • Shaking at idle, weak acceleration

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2304

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication