OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2302

Ignition Coil A Secondary Circuit

P2302 looks at the high-voltage side of coil A – the secondary winding, the boot and the spark plug of cylinder 1 – rather than at the control line covered by P2300 and P2301. Only a few makers use it. FCA does on the 3.6-litre Pentastar V6 in 2015–2016 Dodge Caravan and Chrysler Town & Country vans, where the code name speaks of too little ionization on the secondary side of coil 1: the module judges combustion from the ion current across the plug gap, and a weak signal means the spark did not light the mixture properly. Bulletin 18-069-16 replaced the PCM on vans built between 27 July and 11 September 2015. Ford, by contrast, leaves even primary winding faults of its coil-mounted drivers to the misfire monitor, so they show up as P0301 or P0300. If misfire reaches a catalyst-damaging rate, CARB requires a flashing MIL.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / 02

Possible causes

  • Worn or fouled spark plug in cylinder 1, gap too wide high
  • Cracked coil boot letting the spark jump to the cylinder head medium
  • Secondary winding of coil A breaking down medium
  • Ion-sense evaluation in the PCM (FCA 18-069-16: PCM replaced) low

Symptoms

  • Check engine light on
  • Misfire on cylinder 1, often together with P0301
  • Rough idle and hesitation

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2302

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication