OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P22F8

Cylinder 8 Alternative Fuel Injector Control Circuit Range/Performance

Functional code for the cylinder 8 gas injector circuit, meant for cases where wiring is intact but the valve reacts outside the expected window. No manufacturer documents this code publicly. Both at Ford (2014 list) and at Altech-Eco/TransEco the series stops at P22F6/P22F7 for this cylinder. The reference is therefore CARB, which asks for a check of proper functional response of output components and lets the maker define when it runs. Plausible triggers would be a valve that opens late or not fully, contamination from the gas supply, or a heat-soaked coil at the rear of the engine. Unlike the circuit codes, the fault may show only under certain loads, so a confirmation drive is usually needed after repair.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / F8

Possible causes

  • Cylinder 8 gas valve opening late or partly due to contamination medium
  • Coil degraded by heat at the rear of the engine medium
  • Contact resistance in the injector plug low

Symptoms

  • Hesitation under load in gas mode
  • Cylinder 8 misfire code possible
  • Check engine light possible

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P22F8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication