OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P22F6

Cylinder 8 Alternative Fuel Injector Control Circuit Low

Cylinder 8 is the last cylinder with a generic gas injector code; beyond it the Altech-Eco/TransEco table for the Ford 6.8 V10 switches to manufacturer codes. P22F6 reports a control line for the cylinder 8 valve that is too low. That table counts a short to ground as well as an open line here, with MIL on bi-fuel vehicles only, and Ford's 2014 code list includes the code with MIL. For the driver the effect depends on the fault: a grounded line may keep gas flowing into cylinder 8 and enrich it, a broken one shuts it off. Either way the misfire shows up only in gas mode, which helps separate it from a gasoline injector fault such as P0208. Repair starts with the plug and harness at that valve.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / F6

Possible causes

  • Cylinder 8 control wire grounded through damaged insulation high
  • Open wire or unplugged injector (reported as Low) medium
  • Cylinder 8 gas injector coil defective medium

Symptoms

  • Check engine light on (bi-fuel versions)
  • Misfire on cylinder 8 only in gas mode
  • Gas mode not available

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P22F6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication