OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P22F5

Cylinder 8 Alternative Fuel Injector Control Circuit/Open

Open-circuit code for the gas injector of cylinder 8. No manufacturer documents this code publicly. In the two manufacturer-side lists found, the Ford overview from 2014 and TransEco's sheet for gas-converted Ford V8 and V10 trucks, cylinder 8 has only P22F6 and P22F7, and the TransEco table explicitly assigns an open line to P22F6. CARB permits this shortcut for output circuits. Where P22F5 is used, the module would flag it when no current flows through the cylinder 8 valve after it is commanded on. Typical findings are a pulled or corroded plug at the rear of the bank, a wire broken by engine movement or an internally open coil. That cylinder then gets no gas, while gasoline mode stays usable on bi-fuel trucks.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / F5

Possible causes

  • Cylinder 8 injector plug corroded or disconnected high
  • Wire fatigued at a flex point of the gas harness medium
  • Coil of the cylinder 8 gas valve open medium

Symptoms

  • Cylinder 8 misfire whenever the engine runs on gas
  • Change to gasoline on bi-fuel vehicles
  • Check engine light on

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P22F5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication