OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P22F3

Cylinder 7 Alternative Fuel Injector Control Circuit High

Here the cylinder 7 gas valve drive line is held high, so the output stage cannot switch the valve on. Ford's 2014 list carries P22F3 with MIL; the Altech-Eco/TransEco table for its Ford V8 and V10 CNG systems names a short to power as cause, applies MIL only to bi-fuel trucks and notes that gas module version 1.4 cannot detect this fault itself. Compared with the Low code the picture is clearer: the valve stays shut and cylinder 7 receives no gas, giving a lean misfire on gas while gasoline operation is unaffected. On a dedicated CNG engine there is no second fuel, so the misfire persists until repaired. Under CARB rules such circuit checks run continuously.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / F3

Possible causes

  • Cylinder 7 control wire shorted to a switched or battery feed high
  • Wiring error at the splice between factory and gas harness medium
  • Output stage in the control module open low

Symptoms

  • Lean misfire on cylinder 7 in gas mode
  • Check engine light on (bi-fuel versions)
  • Gas operation dropped in favour of gasoline

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P22F3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication