P22F2
Cylinder 7 Alternative Fuel Injector Control Circuit Low
Low voltage on the control line of the cylinder 7 gas injector. The code appears in Ford's 2014 code list with MIL and in the installer table of the Altech-Eco/TransEco CNG kits, which on Ford's V8 (F-150 5.0) and V10 (Super Duty 6.8) engines use the PCM to drive gas valves for all cylinders; cylinders 9 and 10 of the V10 get manufacturer codes there. That table lumps a short to ground and an open line into this code, so P22F1 is not used, and shows MIL on for bi-fuel and off for dedicated CNG. A grounded line can hold the valve open and flood cylinder 7 with gas, an open line starves it. In both cases gas operation is disturbed, while a bi-fuel truck can still run on gasoline.
Possible causes
- Cylinder 7 injector control wire grounded on the engine or bracket high
- Open wire or poor pin contact (reported as Low) medium
- Cylinder 7 gas injector coil failed medium
Symptoms
- Check engine light on (bi-fuel versions)
- Cylinder 7 misfire or rich running on gas
- Gas mode blocked or ended
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P22F2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.