P22EF
Cylinder 6 Alternative Fuel Injector Control Circuit High
The counterpart to P22EE: the drive line of the cylinder 6 gas injector stays near battery voltage even when the output stage should pull it down. For Ford pickups and vans converted with the Altech-Eco/TransEco CNG kit, the installer sheet gives as cause is a short to power; the same MIL rule applies (on for bi-fuel, off for dedicated CNG), and the column for the gas module version 1.4 marks this fault as not detected there, so on such units only the PCM catches it. Ford carries P22EF with MIL in its 2014 code list. Because the valve can no longer be opened, cylinder 6 runs lean or misfires while on gas, and a bi-fuel engine typically falls back to gasoline. Open wires are not reported here but under the Low code.
Possible causes
- Control wire of the cylinder 6 gas injector touching a battery-voltage feed high
- Gas harness spliced or pinned incorrectly during the conversion medium
- Moisture bridging supply and control pins in the injector plug low
- Output stage in the control module no longer switches low
Symptoms
- Check engine light on (bi-fuel versions)
- Lean misfire on cylinder 6 in gas mode
- Automatic change to gasoline operation
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P22EF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.