OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P22EE

Cylinder 6 Alternative Fuel Injector Control Circuit Low

On engines that burn natural gas or propane through their own gas injectors, the control module watches the drive line of each gas valve. This code means the line to the cylinder 6 gas injector sits at a lower voltage than the switching state allows. The installer table of the Altech-Eco (formerly TransEco) CNG system for Ford F-150, Super Duty and Transit treats both a short to ground and a broken wire as this fault; it lights the MIL on bi-fuel trucks but not on dedicated CNG ones. Ford lists the code with MIL in its 2014 spark-ignition code list and checks it continuously. With a grounded line the valve may stay energised; an open line leaves it shut. Bi-fuel engines usually keep running on gasoline.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / EE

Possible causes

  • Control wire of the cylinder 6 gas injector chafed through to ground high
  • Broken wire or loose plug at the gas injector (counted as Low by this system) medium
  • Gas injector coil burnt open medium
  • Faulty output stage in the PCM or gas control module low

Symptoms

  • Check engine light on (bi-fuel versions)
  • Rough running or misfire on cylinder 6 in gas mode
  • System switches to gasoline or will not enter gas mode

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P22EE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication