OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P22E8

Cylinder 4 Alternative Fuel Injector Control Circuit Range/Performance

P22E8 applies when the cylinder 4 gas injector circuit is complete but the measured response lies outside the plausible range, for instance an opening current that rises too slowly or a hold phase that never settles. No vehicle maker documents P22E8 openly; the published lists from TransEco and Ford end at Low/High. Gas quality is a frequent background factor: GM fits a coalescing filter with a 6 micron element in its bi-fuel pickups because contaminants and liquids in the gas can damage the injectors, and the filter has to be drained and replaced at intervals. A neglected filter can therefore show up as this code. Cleaning rarely helps; the injector or the complete rail is usually replaced, then a drive on gas confirms the repair.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / E8

Possible causes

  • Cylinder 4 injector fouled by oil or liquids, often from a neglected gas filter high
  • Aged injector coil with changed resistance medium
  • Low system voltage during cranking or at idle low

Symptoms

  • Malfunction indicator lamp on
  • Rough idle on gas, smooth on gasoline
  • Gas mode ends after a while

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P22E8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication