P22E7
Cylinder 4 Alternative Fuel Injector Control Circuit High
P22E7 says the control circuit of the cylinder 4 gas injector reads high. TransEco Energy's fault table blames a short to power and lights the MIL for bi-fuel use; Ford's 2014 code list also marks P22E7 as a MIL code. The injector then cannot open and cylinder 4 misfires lean whenever gas is selected. Timing matters for diagnosis: GM's 2015 bi-fuel Impala starts on gasoline below about -20 °C and only moves to CNG once coolant reaches 50 °C, so on such cars the fault may appear only after warm-up. Check the wire for contact with a live feed and measure the injector coil for internal shorts. P22E6 is the low side; P0271 is the corresponding code for the gasoline injector of cylinder 4.
Possible causes
- Cylinder 4 control wire in contact with a 12 V circuit high
- Cylinder 4 injector coil with internal short medium
- Output stage of the controlling module defective low
Symptoms
- Malfunction indicator lamp on
- Cylinder 4 misfire only after the switch to gas
- Reduced power in gas mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P22E7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.