OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P22E6

Cylinder 4 Alternative Fuel Injector Control Circuit Low

P22E6 reports a low signal on the cylinder 4 gas injector control wire. TransEco Energy's AFCM table gives short to ground or open as the cause and turns the MIL on in bi-fuel installations, keeping the same failure response as for gasoline; Ford's 2014 code list carries P22E6 with the MIL as well. On Ford's 2003 bi-fuel CNG system the control module would only start the engine on gas once rail pressure reached about 517 kPa, so a failed gas start alone does not prove an injector fault: check for this code first. A grounded line can hold cylinder 4 permanently open and flood it; an interrupted one leaves it dry. P22E7 is the high side, P22E5 the plain open circuit, and P0270 the gasoline injector code.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / E6

Possible causes

  • Cylinder 4 control wire grounded through damaged insulation high
  • Separated terminal or broken wire in the cylinder 4 circuit medium
  • Damaged driver output in the gas control module low

Symptoms

  • Malfunction indicator lamp on
  • Cylinder 4 runs rich or cuts out on gas
  • Engine stays on or returns to gasoline

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P22E6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication