P22DB
Cylinder 1 Alternative Fuel Injector Control Circuit High
P22DB flags a control circuit of the cylinder 1 gas injector that stays too high. TransEco Energy's AFCM fault list traces it to a short to battery voltage, lights the MIL for bi-fuel use and applies the same fallback as for the gasoline injector fault; Ford's 2014 code list also marks P22DB for the MIL. When the line is held at supply voltage, the driver cannot pull it down, so the injector never opens and cylinder 1 receives no gas: a lean misfire on that cylinder in gas mode is the typical result, often together with P0301. Many output stages also shut off to protect themselves from the excessive current. A coil with shorted turns can look the same. P22DA is the low side, P0262 the code for the gasoline injector.
Possible causes
- Control wire shorted to battery or injector supply voltage high
- Shorted turns in the cylinder 1 gas injector coil medium
- Output stage of the gas control module damaged low
Symptoms
- Malfunction indicator lamp on
- Lean misfire on cylinder 1 in gas mode, often with P0301
- Engine runs normally on gasoline
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P22DB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.