OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P22D7

Turbocharger Turbine Inlet Valve Position Sensor Circuit High

P22D7 is logged when the position signal of the turbine inlet valve rises above its highest valid voltage. A reading pinned near the reference level usually comes from an open sensor ground, a signal wire touching the 5-volt reference or battery voltage, or a failed sensor element, not from the valve itself. Like its low-voltage counterpart P22D6, this is a pure circuit check that runs continuously and does not depend on load. Without valid feedback, the module can no longer run the valve in position control as described in the GM two-stage patent, so it typically fixes the valve and limits boost. No manufacturer publicly documents P22D7. Inspecting the ground pin and wiring near the hot exhaust side usually finds the fault faster than swapping the actuator.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / D7

Possible causes

  • Open or high-resistance sensor ground high
  • Signal wire shorted to the 5-volt reference or battery voltage medium
  • Internal failure of the position sensor medium

Symptoms

  • Check engine light on
  • Reduced power, valve held in fallback position

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P22D7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication