OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P22D6

Turbocharger Turbine Inlet Valve Position Sensor Circuit Low

P22D6 is set when the position sensor signal of the turbine inlet valve falls below its lowest valid voltage. Position sensors on such actuators normally work on a 5-volt reference with a signal that never reaches the rails in normal use, so a reading near zero means a lost reference, a signal wire shorted to ground or an internal sensor fault rather than a real valve position. The engine control module flags this electrically and quickly, without needing a test drive. It then ignores the reading and usually parks the valve in a safe position with reduced boost. Two-stage patents from Ford and GM describe exactly this kind of position feedback on the turbine bypass valve. No manufacturer publicly documents P22D6. Check the reference voltage at the plug first.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / D6

Possible causes

  • 5-volt reference open or pulled down by another shorted sensor high
  • Signal wire shorted to ground medium
  • Internal failure of the position sensor medium

Symptoms

  • Check engine light on
  • Reduced power, valve in fallback position
  • Other sensor codes on the same reference circuit possible

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P22D6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication