P22D4
Turbocharger Turbine Inlet Valve Position Sensor Circuit
P22D4 is the general circuit fault of the sensor that reports how far the turbine inlet valve is open. Engineering literature explains why this valve, unlike most compressor bypass valves, has feedback: a Ford two-stage patent calls the high-pressure turbine bypass valve emissions-critical and therefore actively controlled with a position sensor, and a GM patent uses the measured opening to run the valve in position control. When the signal is missing or cannot be read at all, the module loses that feedback and typically switches to a fixed fallback position with reduced boost. No manufacturer publicly documents P22D4. The narrower sibling codes P22D6 and P22D7 name a too-low or too-high voltage; P22D4 is used when the fault cannot be assigned that precisely.
Possible causes
- Loose, heat-damaged or corroded sensor connector high
- Damaged sensor wiring near the turbo medium
- Failed position sensor, often integrated in the actuator medium
Symptoms
- Check engine light on
- Reduced power, turbo valve held in a fallback position
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P22D4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.