P22D0
Turbocharger Turbine Inlet Valve Control Circuit Low
P22D0 is logged when the drive circuit of the turbine inlet valve shows a voltage below the expected range, the classic sign of a short to ground in the wire or inside the actuator. GM lists P22D0 together with P22CF and P22D1 in the fault bundle of its high-pressure turbine bypass actuator in the 2017 and 2018 diesel OBD documents; any of them takes boost control out of closed loop. Because the exhaust valve sits right on the hot turbo housing, heat-brittle insulation that rubs through is a likely cause. Depending on how the driver is wired, the valve may then stay energized or never move, so exhaust skips the high-pressure stage at the wrong time or never. No public source gives GM's thresholds. P22D0 differs from P22CF by a short rather than a break.
Possible causes
- Heat-damaged wire rubbing through to ground high
- Internal short in the valve actuator or control solenoid medium
- Damaged output stage in the engine control module low
Symptoms
- Check engine light on
- Power limited, boost too low or uneven
- Code sets right after start without a test drive
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P22D0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.