P22CB
Turbocharger Compressor Outlet Switching Valve Control Circuit Low
P22CB is set when the control line of the compressor outlet switching valve shows too little voltage for the present command, most often because the wire or the solenoid has a short to ground. On a low-side driven solenoid such a short can hold the valve energized all the time, so the outlet flap it supplies with vacuum or pressure stays in its switched position whatever the rpm and load. The module spots the fault through its driver diagnostics without any special driving. The solenoid is a small part in the actuating line of the outlet flap and is usually inexpensive; the wiring near the hot turbo area deserves a careful look. No manufacturer publicly documents P22CB. If P22C6 is present as well, look for a shared harness section or connector.
Possible causes
- Control wire chafed and shorted to ground high
- Internal short in the switching solenoid medium
- Water or corrosion in the solenoid connector low
Symptoms
- Check engine light on
- Boost path stuck in one mode, uneven power across the rev range
- Reduced power at low or high engine speed
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P22CB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.