OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P22C6

Turbocharger Compressor Outlet Valve Control Circuit Low

P22C6 is stored when the control line of the compressor outlet valve sits at a voltage that is too low for the current command, which normally points to a short to ground somewhere between the module and the valve. Whether the valve then stays permanently energized or never moves depends on whether the engine control module switches the ground side or the supply side of the coil. The module checks this electrically and needs no driving test, so the code can appear right after start. In a twin-path or two-stage boost layout the valve is meant to open or close one compressor branch on demand; a grounded line therefore leaves that branch in a fixed state. No manufacturer publicly documents P22C6; the description rests on the CARB output-component rules and published two-stage designs. Expect limited boost and a lit warning lamp.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / C6

Possible causes

  • Control wire chafed through and touching ground high
  • Internal short in the valve actuator coil medium
  • Moisture or corrosion bridging pins in the connector medium
  • Damaged output stage in the engine control module low

Symptoms

  • Check engine light on soon after starting
  • Boost limited, engine feels flat under load
  • Possible blown fuse if the short pulls heavy current

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P22C6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication