OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P22C4

O2 Sensor Pumping Current Trim Circuit High (Bank 2 Sensor 2)

P22C4 is the high fault on the trim circuit of the bank 2 downstream wide-band probe. In Ford's key-on check of NTK label resistors, an estimated resistance that is too low means the line is shorted to power, which sets the trim-high code (P2631 for the bank 2 front probe); the stored resistor rank then stays in use. On Bosch-type probes a raised trim voltage looks much like an open: Saab and VW both trip their front trim code above 4.81 V, so makers may sort this fault into the open-circuit code. No maker documents P22C4 publicly, and GM's bank 1 slot P22B7 serves a NOx sensor oxygen ceiling with no bank 2 counterpart. Typical causes are a short to the heater feed or a damaged plug. P22C2 is the open, P22C3 the low case. The lamp lights.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number2 / C4

Possible causes

  • Trim wire shorted to the heater supply or another positive feed high
  • Heat- or water-damaged sensor plug bridging the trim pin medium
  • Internally shorted label resistor in the sensor connector low

Symptoms

  • Check engine light
  • Bank 2 downstream lambda slightly off; heater codes may accompany it

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P22C4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication