P22C3
O2 Sensor Pumping Current Trim Circuit Low (Bank 2 Sensor 2)
P22C3 is the low fault on the trim (label resistor) circuit of the bank 2 post-catalyst wide-band probe. Ford's 2012 OBD summary shows how makers can read this for NTK probes: at each key-on the controller switches the heater off, samples a voltage divider and estimates the label resistor; a value too high is taken as a broken or grounded lead and sets the trim-low code (P2630 for the bank 2 front probe). The controller then falls back to the resistor rank stored in memory, so the reading stays usable but less exact. No maker documents P22C3 publicly, and GM reuses the bank 1 slot P22B6 for a NOx sensor oxygen check without a bank 2 equivalent. P22C2 is the open, P22C4 the high variant. The lamp lights.
Possible causes
- Trim wire chafed and shorted to ground high
- High-resistance or corroded trim terminal raising the measured resistance medium
- Defective label resistor in the sensor connector medium
Symptoms
- Check engine light
- Code typically appears right after engine start
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P22C3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.