P22C2
O2 Sensor Pumping Current Trim Circuit/Open (Bank 2 Sensor 2)
P22C2 reports an open trim line on the bank 2 downstream wide-band probe. Every probe ships with a calibration resistor in its plug (pin 5, RT/IA on a Bosch LSU) that corrects for spread in its diffusion gap; on Bosch probes it sits in parallel with the controller's sense resistor. Ford explains that if it opens, all pump current is forced through that measuring resistor, tilting the lambda curve, a small error near stoichiometry. No maker documents P22C2 publicly. Upstream on bank 2 it is P2629: VW's 2014 Touareg triggers above 4.81 V, Saab tests P2626 during overrun below 750 C, and Ford bulletin 17-2124 replaces the front probes of the 3.5 GTDI for P2626/P2629. P22C3/P22C4 are low/high, P22B5 bank 1. The lamp lights.
Possible causes
- Corroded or loose trim-resistor terminal in the sensor plug high
- Trim resistor or its lead open inside the sensor connector medium
- Trim wire broken between connector and control module low
Symptoms
- Check engine light
- Bank 2 downstream lambda reads slightly off, most visibly away from lambda 1
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P22C2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- bosch-motorsport.com/content/downloads/Raceparts/Resources/pdf/Data Sheet_69034379_Lambda_Sensor_LSU_4.9.pdf
- newtonnet.co.uk/fiesta/fordobd2012.pdf
- static.nhtsa.gov/odi/tsbs/2014/MC-10074008-2280.pdf
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p2237-p2239-p2243-p2251-or-p2626
- static.nhtsa.gov/odi/tsbs/2017/MC-10115945-9999.pdf