P22C1
O2 Sensor Negative Current Control Circuit High (Bank 2 Sensor 2)
P22C1 covers a return line (virtual ground) reading too high on the bank 2 post-catalyst wide-band probe: the line is pushed above the mid-level bias the controller sets, which in practice means contact with the heater supply or battery voltage, often via a melted or wet connector. With the reference raised, the rich side of the scale is lost and the oxygen value becomes useless. No maker documents this code publicly. Mitsubishi names the bank 1 front analog P2253 as a two-trip code on the 2022 Outlander, and Ford's front-probe logic books shorts to battery on any Bosch pin as P0152 for bank 2. CARB expects out-of-range detection on secondary sensors. P22BF is the open, P22C0 the low case, P22B4 bank 1. The lamp lights; the engine runs on.
Possible causes
- Return wire touching the heater feed or another positive supply high
- Heat-damaged or wet connector bridging the return to a live pin medium
- Internal leakage from heater to sensing cells inside the probe medium
Symptoms
- Check engine light
- Bank 2 downstream reading stuck high or implausible
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P22C1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.