P22C0
O2 Sensor Negative Current Control Circuit Low (Bank 2 Sensor 2)
P22C0 flags the negative current control line (virtual ground) of the bank 2 downstream wide-band probe as too low. The controller deliberately lifts this return above chassis ground, around 2.5 V on Saab's 2010 9-5, which lets the pump cell be driven both ways; once the wire touches ground, that bias and the lean side of the measuring range disappear. No maker documents this code publicly. Mitsubishi lists the bank 1 front analog P2252 as a two-trip code on the 2022 Outlander without giving a limit, and Ford reports shorts to ground on the VM pin of its front bank 2 probes as P0151 rather than a dedicated code. P22BF is the open, P22C1 the high reading, P22B3 bank 1. Apart from the lamp, little changes for the driver.
Possible causes
- Return wire chafed against body or exhaust bracket, shorted to ground high
- Internal short from the sensor return to the housing medium
- Faulty bias supply in the engine control module low
Symptoms
- Check engine light
- Bank 2 downstream reading cannot show lean values
- Readiness for catalyst and oxygen sensor monitors stays open
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P22C0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- static.nhtsa.gov/odi/tsbs/2023/MC-10237505-0001.pdf
- newtonnet.co.uk/fiesta/fordobd2012.pdf
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p2237-p2239-p2243-p2251-or-p2626
- law.cornell.edu/regulations/california/13-CCR-1968.2