P22BC
O2 Sensor Reference Voltage Performance (Bank 2 Sensor 2)
P22BC concerns the plausibility of the Nernst-cell signal of the wide-band probe fitted after the bank 2 catalyst. The leads test fine, yet the cell voltage that the controller uses as its set point drifts, reacts slowly or cannot be held, so the computed oxygen value loses credibility. No maker documents this code publicly, and none publishes a limit for its upstream relative P2248 either. The usual reasons are physical: an aged cell whose resistance has climbed well above the nominal 300 ohms of a Bosch LSU 4.9, deposits from oil or coolant, or a weak heater. CARB requires a downstream sensor to remain good enough to judge the catalyst. Siblings: P22BB open, P22BD/P22BE low/high, P22AF bank 1. The lamp lights and catalyst results may be withheld.
Possible causes
- Aged downstream wide-band sensor on bank 2 with raised Nernst-cell resistance high
- Oil, coolant or additive deposits on the sensing element medium
- Heater output too low to keep the cell at working temperature low
- Contact resistance in the Nernst-cell terminal low
Symptoms
- Check engine light
- Bank 2 downstream oxygen reading lags behind or is offset from the other sensors
- Catalyst monitor for bank 2 does not complete
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P22BC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.